Prusa3D Forum

Notifications

Clear all

XavAcid

Group: Registered

Joined: 2016/12/20

Active Member

	It happened to me once, because I didn't have it tight enoug... In forum Assembly and first prints troubleshooting	9 years ago
	this is mine. In forum Prusa i3 kit (Archive)	9 years ago
	Ok I went around and tighten some screws that felt loose. An... In forum Prusa i3 kit (Archive)	9 years ago
	Can I just go to the store and tell them I need ato 5 amp fu... In forum Prusa i3 kit (Archive)	9 years ago
	My pinda is only slightly higher than the nozzle. The light ... In forum Prusa i3 kit (Archive)	9 years ago
	XYZ calibration failed at the 4th point In forum Prusa i3 kit (Archive)	9 years ago
	I just pulled the F3 fuse, and yes it is blown ( looked from... In forum Prusa i3 kit (Archive)	9 years ago
	I think I've blown a fuse from gripping the heat block too t... In forum Prusa i3 kit (Archive)	9 years ago
	Thank you so much! I'm gonna have to order the ABS. Learni... In forum Prusa i3 kit (Archive)	9 years ago
	PINDA prob hold just broke In forum Prusa i3 kit (Archive)	9 years ago
	Ok, I've seemed to solve it now. I did the atomic pull one ... In forum Prusa i3 kit (Archive)	9 years ago
	clogged nozzle? In forum Prusa i3 kit (Archive)	9 years ago

Forum Statistics

585 Forums

68.1 K Topics

477.1 K Posts

12 Online

75.7 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed