Prusa3D Forum

Notifiche

Cancella tutti

WizardUli

Gruppo: Registrato

Registrato: 2015/05/22

Active Member

	Same here. Sometimes it is so hard to get it from PTFE tubes... Nel forum General discussion, announcements and releases	2 years fa
	Let us know how it goes! Nel forum How do I print this? (Printing help)	3 years fa
	@jsw, @swiss_cheese I do NOT have any problems with bed adhe... Nel forum How do I print this? (Printing help)	3 years fa
	How it went? Nel forum How do I print this? (Printing help)	3 years fa
	1. It does NOT loose any adhesion during print. I had though... Nel forum How do I print this? (Printing help)	3 years fa
	@jsw: I'm printing in an enclosure and Einsy reports stable ... Nel forum How do I print this? (Printing help)	3 years fa
	@Tobbe I've not only redone Z calibration but also redone XY... Nel forum Hardware, firmware and software help	3 years fa
	ABS not warping up on edges but bulging up in the middle! Nel forum How do I print this? (Printing help)	3 years fa
	I've applied the nylock mod and it solved the problem. Nel forum Hardware, firmware and software help	3 years fa
	Bulging bed when heated Nel forum Hardware, firmware and software help	3 years fa
	Dimensional accuracy - XY position - relative error Nel forum General discussion, announcements and releases	5 years fa

Statistiche Forum

565 Forum

63.9 K Discussioni

447.7 K Post

22 Online

69.5 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso