Prusa3D Forum

Notifications

Clear all

WizardUli

Group: Registered

Joined: 2015/05/22

Active Member

	Same here. Sometimes it is so hard to get it from PTFE tubes... In forum General discussion, announcements and releases	2 years ago
	Let us know how it goes! In forum How do I print this? (Printing help)	3 years ago
	@jsw, @swiss_cheese I do NOT have any problems with bed adhe... In forum How do I print this? (Printing help)	3 years ago
	How it went? In forum How do I print this? (Printing help)	3 years ago
	1. It does NOT loose any adhesion during print. I had though... In forum How do I print this? (Printing help)	3 years ago
	@jsw: I'm printing in an enclosure and Einsy reports stable ... In forum How do I print this? (Printing help)	3 years ago
	@Tobbe I've not only redone Z calibration but also redone XY... In forum Hardware, firmware and software help	3 years ago
	ABS not warping up on edges but bulging up in the middle! In forum How do I print this? (Printing help)	3 years ago
	I've applied the nylock mod and it solved the problem. In forum Hardware, firmware and software help	3 years ago
	Bulging bed when heated In forum Hardware, firmware and software help	3 years ago
	Dimensional accuracy - XY position - relative error In forum General discussion, announcements and releases	5 years ago

Forum Statistics

565 Forums

63.9 K Topics

447.7 K Posts

21 Online

69.5 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed