Notifiche
Cancella tutti
Wilson Kong
Gruppo: Registrato
Registrato: 2020/07/26
Active Member
1
|
YES!!!! "avoid crossing perimeters" is exactly what I needed... Nel forum PrusaSlicer |
7 months fa | |
|
Tool travel to avoid certain areas Nel forum PrusaSlicer |
7 months fa | |
|
No worries, @n33kos I struggled because the official guide d... Nel forum Hardware, firmware and software help |
11 months fa | |
|
Firmware update for Mini (from 4.3.4 to 5.1.0) Nel forum Hardware, firmware and software help |
11 months fa | |
| @peter-m26 Thanks, I'll have a look at this. | 4 years fa | |
| @joantabb Thanks for the suggestion. I will give it a more t... | 4 years fa | |
| Inconsistent layer adhesion issue | 4 years fa |