Notifications
Clear all
William
Skupina: Registrovaný
Přidal se: 2021/04/14
Active Member
1
| Correct, core one is passive heating up to 55 C (and can tak... | před 8 months | |
| I appreciate all the replies! I'm especially looking for fea... | před 1 year | |
| Octoprint with mk4s status? | před 1 year | |
|
Great feedback! Sadly, as best I can tell I can't edit it to... In forum PrusaSlicer |
před 4 years | |
|
[Guide] Config PrusaSlicer to send/print to Octoprint on but... In forum PrusaSlicer |
před 5 years | |
|
I just had this problem and just fixed it. Go into octoprint... In forum Hardware, firmware and software help |
před 5 years |