Prusa3D Forum

Notifications

Clear all

wilkinsaf

Groupe: Enregistré

A(ont) rejoint: 2020/11/14

Active Member

	@cwbullet E3D v6. In the photo attached, 1 came apart from 2... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	whoops, different account. I wish Prusa made it easier to up... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	@dan-rogers Thank you for that detailed response! It does ap... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Perfection. Thanks again! Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	I am printing off a piece right now, and will post the final... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	This is after tightening the x-axis pulley. An absolute rook... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	I still need to do the life-z as well Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@tim-m30, You were correct. There was a bit of play in the X... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@karl-herbert I am going to do the life-z. I missed that in ... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Before Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	I am going to try this, and post the results here:/p> Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Sorry, didn't read @karl-herbert post correctly. I need to d... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@karl-herbert I did the mesh bed calibration, but this did n... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@karl-herbert Thank you! I did do a Z adjustment, but I do n... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Right side of print always off Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Statistiques du forum

559 Forums

63 K Sujets

443.1 K Messages

21 En-ligne

67.8 K Membres

Le dernier des messages: One word of caution / Wichtiger Hinweis Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé