Notifications
Clear all
wilkinsaf
Skupina: Registrovaný
Přidal se: 2020/11/14
Active Member
1
| @cwbullet E3D v6. In the photo attached, 1 came apart from 2... | před 4 years | |
| whoops, different account. I wish Prusa made it easier to up... | před 4 years | |
| @dan-rogers Thank you for that detailed response! It does ap... | před 4 years | |
| Perfection. Thanks again! | před 5 years | |
| I am printing off a piece right now, and will post the final... | před 5 years | |
| This is after tightening the x-axis pulley. An absolute rook... | před 5 years | |
| I still need to do the life-z as well | před 5 years | |
| @tim-m30, You were correct. There was a bit of play in the X... | před 5 years | |
| @karl-herbert I am going to do the life-z. I missed that in ... | před 5 years | |
| Before | před 5 years | |
| I am going to try this, and post the results here:/p> | před 5 years | |
| Sorry, didn't read @karl-herbert post correctly. I need to d... | před 5 years | |
| @karl-herbert I did the mesh bed calibration, but this did n... | před 5 years | |
| @karl-herbert Thank you! I did do a Z adjustment, but I do n... | před 5 years | |
| Right side of print always off | před 5 years |