Notifications
Clear all
wieman01
wieman01
Skupina: Registrovaný
Přidal se: 2019/02/21
Estimable Member
4
Thank your clearing that up, Ron. I have removed them entire...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
I am also chiming in since I am going through the same exerc...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
Hello, I was finally able to fix this. I mistakenly thought ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
Rainer, Please don't spend anymore time on this, I am onto s...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
Thank you, Rainer. And don't worry about the "Single extrude...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
Thanks for getting back to me. Yes, I exclusively work in th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
My apologies, I missed the underscore. But the result is the...

In forum Hardware, firmware and software help

před 5 years
Hello, I have been watching this thread for a while and I am...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
I think we can close this thread. This has not been implemen...

In forum Hardware, firmware and software help

před 5 years
Issue with G-Code for tool change ("next_extruder")

In forum Hardware, firmware and software help

před 5 years
Can you share a few more details concerning your print setti...

In forum Hardware, firmware and software help

před 5 years
Yes, this happens when the ambient temperatures increases be...

In forum Hardware, firmware and software help

před 5 years
A clicking noise is never a good sign and made lead to under...

In forum How do I print this? (Printing help)

před 5 years
Yes, counter-intuitive was the word that came to my mind whe...

In forum How do I print this? (Printing help)

před 5 years
That is right. Airflows cause variation in ambient temperatu...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
You are out of luck if you are trying to print any plastics ...

In forum How do I print this? (Printing help)

před 5 years
Also the question remains why you would want to build an enc...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 5 years
Depending on the material you use and what temperature is pr...

In forum Assembly and first prints troubleshooting

před 5 years
Hello Tim, The issue at hand turned out to be more complex t...

In forum How do I print this? (Printing help)

před 5 years
@tim-m30 Thank you, I'll look into this and report back when...

In forum How do I print this? (Printing help)

před 5 years
Stránka 2 / 7
Share: