Prusa3D Forum

Notifications

Clear all

wbphelps

Groupe: Enregistré

A(ont) rejoint: 2024/10/27

Active Member

	there are several on Thingiverse. I like to simplify things... Dans le forum Hardware, firmware and software help	il y a 3 months
	I gave up and went with an alternative nozzle cleaner from T... Dans le forum Hardware, firmware and software help	il y a 3 months
	With 6.3.3 I don't seem to have any nozzle cleaning problems... Dans le forum Hardware, firmware and software help	il y a 3 months
	If the side filament sensor is not working - always displays... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	Assuming one has both the connector that Prusa uses (clik-ma... Dans le forum Hardware, firmware and software help	il y a 3 months
	End G-code Park position no longer works Dans le forum Hardware, firmware and software help	il y a 10 months
	For those interested in PETG with PLA supports, I just disco... Dans le forum How do I print this? (Printing help)	il y a 3 years
	If you use PETG for the supports, they are nearly impossible... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Using PLA as support material for PETG is the bomb! I've be... Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

585 Forums

68 K Sujets

476.5 K Messages

15 En-ligne

75.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé