Prusa3D Forum

Notifications

Clear all

Wandroid

Grupa: Zarejestrowany

Dołączył: 2019/12/05

Active Member

	Got it! Discovered that the hot-end block is threaded onto t... In forum Hardware, firmware and software help	5 years temu
	MK3S Hot end loose on fin-stack. ABS filament completely jam... In forum Hardware, firmware and software help	5 years temu
	Eventually got it to print by lowering 'move' rates and rais... In forum How do I print this? (Printing help)	5 years temu
	@bobstro Thanks. It is only this silky filament that's givin... In forum How do I print this? (Printing help)	5 years temu
	Other filaments seem to print fine with pretty much identica... In forum How do I print this? (Printing help)	5 years temu
	BTW the Prusa badge print from the SD card looks pretty good... In forum How do I print this? (Printing help)	5 years temu
	Blobs on extrusion direction changes only with one brand of ... In forum How do I print this? (Printing help)	5 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.6 K Posty

21 Online

68 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte