Prusa3D Forum

Notifications

Clear all

Wandroid

Skupina: Registrovaný

Přidal se: 2019/12/05

Active Member

	Got it! Discovered that the hot-end block is threaded onto t... In forum Hardware, firmware and software help	před 5 years
	MK3S Hot end loose on fin-stack. ABS filament completely jam... In forum Hardware, firmware and software help	před 5 years
	Eventually got it to print by lowering 'move' rates and rais... In forum How do I print this? (Printing help)	před 5 years
	@bobstro Thanks. It is only this silky filament that's givin... In forum How do I print this? (Printing help)	před 5 years
	Other filaments seem to print fine with pretty much identica... In forum How do I print this? (Printing help)	před 5 years
	BTW the Prusa badge print from the SD card looks pretty good... In forum How do I print this? (Printing help)	před 5 years
	Blobs on extrusion direction changes only with one brand of ... In forum How do I print this? (Printing help)	před 5 years

Fórum Statistiky

565 Fóra

64.5 K Témata

451.8 K Příspěvky

26 Online

71.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed