Prusa3D Forum

Notifications

Clear all

walt_3d

Grupa: Zarejestrowany

Dołączył: 2022/08/12

Active Member

	Thanks much! Excellent information. Will try the g-code mods... In forum Hardware, firmware and software help	2 years temu
	I had the same issue. and suspect it was the reason that rec... In forum Hardware, firmware and software help	2 years temu
	@neophyl Thank you very much for the explanation. I can see ... In forum PrusaSlicer	2 years temu
	Now the correct one 20mm_hollow_cube- open top 2.3mf In forum PrusaSlicer	2 years temu
	OK, tried 'Attach file', now going for 'Add Media' 20mm_holl... In forum PrusaSlicer	2 years temu
	At least it says I am attaching a file, but I don't see it i... In forum PrusaSlicer	2 years temu
	@Ringarn67 Thanks for the tip. In the context of better-la... In forum PrusaSlicer	2 years temu
	Thanks! Being relatively new to 3D printing and PrusaSlicer ... In forum PrusaSlicer	2 years temu
	Hollow calibration cube without top - prints 'top' In forum PrusaSlicer	2 years temu
	I'm definitely going to try loosening the tensioner a little... In forum Hardware, firmware and software help	2 years temu
	The hint to move the extruder from the Settings menu with th... In forum Hardware, firmware and software help	2 years temu

Statystyki Forum

566 Fora

63.1 K Tematy

444.1 K Posty

21 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte