Prusa3D Forum

Notifications

Clear all

walt_3d

Skupina: Registrovaný

Přidal se: 2022/08/12

Active Member

	Nice! A perfect solution if I was in a similar situation. Th... In forum General discussion, announcements and releases	před 1 month
	MK3 parts after upgrade In forum General discussion, announcements and releases	před 1 month
	Thanks much! Excellent information. Will try the g-code mods... In forum Hardware, firmware and software help	před 2 years
	I had the same issue. and suspect it was the reason that rec... In forum Hardware, firmware and software help	před 2 years
	@neophyl Thank you very much for the explanation. I can see ... In forum PrusaSlicer	před 3 years
	Now the correct one 20mm_hollow_cube- open top 2.3mf In forum PrusaSlicer	před 3 years
	OK, tried 'Attach file', now going for 'Add Media' 20mm_holl... In forum PrusaSlicer	před 3 years
	At least it says I am attaching a file, but I don't see it i... In forum PrusaSlicer	před 3 years
	@Ringarn67 Thanks for the tip. In the context of better-la... In forum PrusaSlicer	před 3 years
	Thanks! Being relatively new to 3D printing and PrusaSlicer ... In forum PrusaSlicer	před 3 years
	Hollow calibration cube without top - prints 'top' In forum PrusaSlicer	před 3 years
	I'm definitely going to try loosening the tensioner a little... In forum Hardware, firmware and software help	před 3 years
	The hint to move the extruder from the Settings menu with th... In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

567 Fóra

64.7 K Témata

453.2 K Příspěvky

22 Online

71.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed