Notifications
Clear all
wakareva
Skupina: Registrovaný
Přidal se: 2021/03/15
Active Member
1
|
start and end problem of each layer (or line) - linear advan... In forum Hardware, firmware and software help |
před 3 years | |
| Hi! Thanks, I did all this steps before write the post. The ... | před 4 years | |
| fine tuning - wrinkled surface against the light | před 4 years | |
|
@clarmrrsn I've tested right now the belts and they are insi... In forum How do I print this? (Printing help) |
před 5 years | |
|
Z not aligned levels In forum How do I print this? (Printing help) |
před 5 years | |
| Hi All,I've enabled the 7x7. After all the tuning I've some ... | před 5 years | |
| First layer - too low or too high? | před 5 years |