start and end problem of each layer (or line) - linear advance ?
 
Notifications
Clear all

start and end problem of each layer (or line) - linear advance ?  

  RSS
wakareva
(@wakareva)
Active Member
start and end problem of each layer (or line) - linear advance ?

premise, I have owned the printer for 2 years and it has never presented this problem and I use more or less always the same type of filament. In the last prints this problem has arisen, at the beginning and end of each printed section (layer or line) it has this defect. In your opinion is this a problem of linear advance ( https://help.prusa3d.com/article/linear-advance_2252 ), printing speed, something else?

Thank you.

T.

Posted : 03/10/2022 7:39 am
Diem
 Diem
(@diem)
Famed Member

Your nozzle has worn slightly, tweak your first layer Z calibration.

Cheerio,

Posted : 03/10/2022 9:07 am
Share: