|
Thank you. En el foro Hardware, firmware and software help |
hace 6 years |
|
Thanks. I also found that if I right clicked and had it repa... En el foro Hardware, firmware and software help |
hace 6 years |
|
Sorry for being ignorant about this but where would I go to ... En el foro Hardware, firmware and software help |
hace 6 years |
|
Yes the second screenshot is from the older version of slic3... En el foro Hardware, firmware and software help |
hace 6 years |
|
Lithophane layers missing En el foro Hardware, firmware and software help |
hace 6 years |
|
Sorry for the pics. I tend to get a lot of stringing in almo... En el foro How do I print this? (Printing help) |
hace 6 years |
|
Sorry for the pics. I tend to get a lot of stringing in almo... En el foro How do I print this? (Printing help) |
hace 6 years |
|
Help with PETG Profile En el foro How do I print this? (Printing help) |
hace 6 years |
|
Thank you both for the help. I had to do a little of both. P... En el foro How do I print this? (Printing help) |
hace 6 years |
|
Thank you. I will give this a shot and reply back. En el foro How do I print this? (Printing help) |
hace 6 years |
|
Negative numbers mean closer to teh bed, Correct? En el foro How do I print this? (Printing help) |
hace 6 years |
|
Attached Photo En el foro How do I print this? (Printing help) |
hace 6 years |
|
Non Level Print Bed, I think, En el foro How do I print this? (Printing help) |
hace 6 years |
|
Wanted to post a reply to this. The filament was so jammed i... En el foro Hardware, firmware and software help |
hace 7 years |
|
Thanks I will do that. I am pretty sure I had the fan the ri... En el foro Hardware, firmware and software help |
hace 7 years |
|
Filament Jam En el foro Hardware, firmware and software help |
hace 7 years |
