Notifications
Clear all
VitruViper
VitruViper
Group: Registered
Joined: 2018/01/18
Active Member
1
Thank you.

In forum Hardware, firmware and software help

6 years ago
Thanks. I also found that if I right clicked and had it repa...

In forum Hardware, firmware and software help

6 years ago
Sorry for being ignorant about this but where would I go to ...

In forum Hardware, firmware and software help

6 years ago
Yes the second screenshot is from the older version of slic3...

In forum Hardware, firmware and software help

6 years ago
Lithophane layers missing

In forum Hardware, firmware and software help

6 years ago
Sorry for the pics. I tend to get a lot of stringing in almo...

In forum How do I print this? (Printing help)

6 years ago
Sorry for the pics. I tend to get a lot of stringing in almo...

In forum How do I print this? (Printing help)

6 years ago
Help with PETG Profile

In forum How do I print this? (Printing help)

6 years ago
Thank you both for the help. I had to do a little of both. P...

In forum How do I print this? (Printing help)

6 years ago
Thank you. I will give this a shot and reply back.

In forum How do I print this? (Printing help)

6 years ago
Negative numbers mean closer to teh bed, Correct?

In forum How do I print this? (Printing help)

6 years ago
Attached Photo

In forum How do I print this? (Printing help)

6 years ago
Non Level Print Bed, I think,

In forum How do I print this? (Printing help)

6 years ago
Wanted to post a reply to this. The filament was so jammed i...

In forum Hardware, firmware and software help

7 years ago
Thanks I will do that. I am pretty sure I had the fan the ri...

In forum Hardware, firmware and software help

7 years ago
Filament Jam

In forum Hardware, firmware and software help

7 years ago
Share: