|
Thank you. In forum Hardware, firmware and software help |
6 years ago |
|
Thanks. I also found that if I right clicked and had it repa... In forum Hardware, firmware and software help |
6 years ago |
|
Sorry for being ignorant about this but where would I go to ... In forum Hardware, firmware and software help |
6 years ago |
|
Yes the second screenshot is from the older version of slic3... In forum Hardware, firmware and software help |
6 years ago |
|
Lithophane layers missing In forum Hardware, firmware and software help |
6 years ago |
|
Sorry for the pics. I tend to get a lot of stringing in almo... In forum How do I print this? (Printing help) |
6 years ago |
|
Sorry for the pics. I tend to get a lot of stringing in almo... In forum How do I print this? (Printing help) |
6 years ago |
|
Help with PETG Profile In forum How do I print this? (Printing help) |
6 years ago |
|
Thank you both for the help. I had to do a little of both. P... In forum How do I print this? (Printing help) |
6 years ago |
|
Thank you. I will give this a shot and reply back. In forum How do I print this? (Printing help) |
6 years ago |
|
Negative numbers mean closer to teh bed, Correct? In forum How do I print this? (Printing help) |
6 years ago |
|
Attached Photo In forum How do I print this? (Printing help) |
6 years ago |
|
Non Level Print Bed, I think, In forum How do I print this? (Printing help) |
6 years ago |
|
Wanted to post a reply to this. The filament was so jammed i... In forum Hardware, firmware and software help |
6 years ago |
|
Thanks I will do that. I am pretty sure I had the fan the ri... In forum Hardware, firmware and software help |
6 years ago |
|
Filament Jam In forum Hardware, firmware and software help |
6 years ago |
