Prusa3D Forum

Notifications

Clear all

Vinsmoke_sanji

Grupa: Zarejestrowany

Dołączył: 2017/11/13

Active Member

	hey , thanks for rply i asked support staff for little to ... In forum Hardware, firmware and software help	6 years temu
	First layer, no extrusion In forum Hardware, firmware and software help	6 years temu
	Error : preheat the nozzel In forum Hardware, firmware and software help	6 years temu
	Mk3 slicer not installed In forum Hardware, firmware and software help	6 years temu
	Thanks david That thread explain a lot. In forum Others (Archive)	7 years temu
	Thanks Fabrik And Dreambox. I will try what u have sugges... In forum Others (Archive)	7 years temu
	Hey stefan, Can u explain more about live z adujstment -0.10... In forum Others (Archive)	7 years temu
	In handbook its recommended hieght is around -0.100 . What u... In forum Others (Archive)	7 years temu
	Hey, I tried printing with increase bed tempetrature around ... In forum Others (Archive)	7 years temu
	driver error on window In forum Software (Archive)	7 years temu
	Print fail: Sd card model pop off after printing few layers In forum Others (Archive)	7 years temu

Statystyki Forum

566 Fora

63.2 K Tematy

444.3 K Posty

22 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte