Prusa3D Forum

Notifications

Clear all

Vinsmoke_sanji

Skupina: Registrovaný

Přidal se: 2017/11/13

Active Member

	hey , thanks for rply i asked support staff for little to ... In forum Hardware, firmware and software help	před 6 years
	First layer, no extrusion In forum Hardware, firmware and software help	před 6 years
	Error : preheat the nozzel In forum Hardware, firmware and software help	před 6 years
	Mk3 slicer not installed In forum Hardware, firmware and software help	před 6 years
	Thanks david That thread explain a lot. In forum Others (Archive)	před 7 years
	Thanks Fabrik And Dreambox. I will try what u have sugges... In forum Others (Archive)	před 7 years
	Hey stefan, Can u explain more about live z adujstment -0.10... In forum Others (Archive)	před 7 years
	In handbook its recommended hieght is around -0.100 . What u... In forum Others (Archive)	před 7 years
	Hey, I tried printing with increase bed tempetrature around ... In forum Others (Archive)	před 7 years
	driver error on window In forum Software (Archive)	před 7 years
	Print fail: Sd card model pop off after printing few layers In forum Others (Archive)	před 7 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.8 K Příspěvky

18 Online

67.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed