Attività
 
Notifiche
Cancella tutti
tsamisa
tsamisa
Gruppo: Registrato
Registrato: 2019/01/30
Estimable Member
4
Same here. Lets hope this is not the case.

Nel forum General discussion, announcements and releases

2 years fa
that is really good news. I can hardly wait.

Nel forum General discussion, announcements and releases

2 years fa
Well some complain just to to vent and this is an understand...

Nel forum General discussion, announcements and releases

2 years fa
Prusa is not a negligible customer either. I mean its a well...

Nel forum General discussion, announcements and releases

2 years fa
I kind of agree with Artur5. I know there are supply chain...

Nel forum General discussion, announcements and releases

2 years fa
I really hope that this is the case but for a company that d...

Nel forum General discussion, announcements and releases

2 years fa
Exactly. There seems to be a misunderstanding here that the ...

Nel forum General discussion, announcements and releases

2 years fa
@richard-3 Not only that but 3d printers don't tolerate part...

Nel forum General discussion, announcements and releases

2 years fa
After a lot of tinkering, the blade firmware update and usin...

Nel forum General discussion, announcements and releases

2 years fa
I got the same problem on my SLS with 1.7 firmware. Anyone g...

Nel forum Hardware, firmware and software help

2 years fa
That is what we asked. An update. Me and i believe the major...

Nel forum General discussion, announcements and releases

2 years fa
This forum expiration "tactic" is bothersome. Following my p...

Nel forum General discussion, announcements and releases

2 years fa
RE: Original Prusa XL Dev Diary #1 and FAQ

Nel forum General discussion, announcements and releases

2 years fa
I have an MMU2S. The only thing that the prusa slicer allows...

Nel forum General discussion, announcements and releases

3 years fa
My 85% translates as a success if i dont intervene at all or...

Nel forum How do I print this? (Printing help)

3 years fa
@reddog2 I don't have a pallete but i read about it a bit an...

Nel forum How do I print this? (Printing help)

3 years fa
This is my personal opinion based solely on my experience. I...

Nel forum General discussion, announcements and releases

3 years fa
I had a similar problem. I live in a country with a hot summ...

Nel forum Hardware, firmware and software help

4 years fa
@gnat Especially the prusa support issue. I opened a call at...

Nel forum General discussion, announcements and releases

4 years fa
@zhev What i did with mmu2s was to write down the configurat...

Nel forum How do I print this? (Printing help)

4 years fa
Pagina 8 / 11
Condividi: