Actividad
 
Avisos
Vaciar todo
tsamisa
tsamisa
Grupo: Registrado
Registrado: 2019/01/30
Estimable Member
4
Same here. Lets hope this is not the case.

En el foro General discussion, announcements and releases

hace 2 years
that is really good news. I can hardly wait.

En el foro General discussion, announcements and releases

hace 2 years
Well some complain just to to vent and this is an understand...

En el foro General discussion, announcements and releases

hace 2 years
Prusa is not a negligible customer either. I mean its a well...

En el foro General discussion, announcements and releases

hace 2 years
I kind of agree with Artur5. I know there are supply chain...

En el foro General discussion, announcements and releases

hace 2 years
I really hope that this is the case but for a company that d...

En el foro General discussion, announcements and releases

hace 2 years
Exactly. There seems to be a misunderstanding here that the ...

En el foro General discussion, announcements and releases

hace 2 years
@richard-3 Not only that but 3d printers don't tolerate part...

En el foro General discussion, announcements and releases

hace 2 years
After a lot of tinkering, the blade firmware update and usin...

En el foro General discussion, announcements and releases

hace 2 years
I got the same problem on my SLS with 1.7 firmware. Anyone g...

En el foro Hardware, firmware and software help

hace 2 years
That is what we asked. An update. Me and i believe the major...

En el foro General discussion, announcements and releases

hace 2 years
This forum expiration "tactic" is bothersome. Following my p...

En el foro General discussion, announcements and releases

hace 2 years
RE: Original Prusa XL Dev Diary #1 and FAQ

En el foro General discussion, announcements and releases

hace 2 years
I have an MMU2S. The only thing that the prusa slicer allows...

En el foro General discussion, announcements and releases

hace 3 years
My 85% translates as a success if i dont intervene at all or...

En el foro How do I print this? (Printing help)

hace 3 years
@reddog2 I don't have a pallete but i read about it a bit an...

En el foro How do I print this? (Printing help)

hace 3 years
This is my personal opinion based solely on my experience. I...

En el foro General discussion, announcements and releases

hace 3 years
I had a similar problem. I live in a country with a hot summ...

En el foro Hardware, firmware and software help

hace 4 years
@gnat Especially the prusa support issue. I opened a call at...

En el foro General discussion, announcements and releases

hace 4 years
@zhev What i did with mmu2s was to write down the configurat...

En el foro How do I print this? (Printing help)

hace 4 years
Página 8 / 11
Compartir: