|
Awesome thanks. In forum Hardware, firmware and software help |
před 2 months |
|
Will do, thanks for that, if left for 5+ mins the heat sprea... In forum Hardware, firmware and software help |
před 2 months |
|
Hey Diem,
I got the new sheet and it is doing the same, b... In forum Hardware, firmware and software help |
před 2 months |
|
Sorry didn't realise there were different options, is the ba... In forum Hardware, firmware and software help |
před 3 months |
|
No problem and makes sense, as I do often flex the sheet whi... In forum Hardware, firmware and software help |
před 3 months |
|
Hey Diem, firstly thanks for your help with this. I should’v... In forum Hardware, firmware and software help |
před 3 months |
|
While cold, there was enough gap to slip a piece of paper bu... In forum Hardware, firmware and software help |
před 3 months |
|
I put it onto a flat surface and its completely flat to my e... In forum Hardware, firmware and software help |
před 3 months |
|
It is quite old about 6-8 years and same on both sides, I pr... In forum Hardware, firmware and software help |
před 3 months |
|
Update: I forgot to mention if I print off centred, then I d... In forum Hardware, firmware and software help |
před 3 months |
|
Spring steel sheet bowing / flexing mid print In forum Hardware, firmware and software help |
před 3 months |
|
Hey Diem, Thanks for there response and I cleaned the bed a... In forum Hardware, firmware and software help |
před 4 months |
|
First layer defects / blobs / artefacts - Not sure why In forum Hardware, firmware and software help |
před 4 months |
