Actividad
 
Avisos
Vaciar todo
Trae
Trae
Grupo: Registrado
Registrado: 2017/10/03
Active Member
1
Is just a self test needed to calibrate, or should I do the ...

En el foro Others (Archive)

hace 7 years
Giving this merge a shot. First thing I notice is the motors...

En el foro Others (Archive)

hace 7 years
Paul, I've printed and mounted the PSU with your model. The...

En el foro Hardware, firmware and software help

hace 7 years
Are those files for the slim 350w mean well PSU or the regul...

En el foro Hardware, firmware and software help

hace 7 years
Mode 2 sounds about right. Pretty frustrating experience rig...

En el foro Hardware, firmware and software help

hace 7 years
I'm using NES-350-24. Would love to check out those models!

En el foro Hardware, firmware and software help

hace 7 years
Been using this firmware since Friday. With crash detection ...

En el foro Others (Archive)

hace 7 years
So my PSU just failed. Nothing as dramatic, but about 30 min...

En el foro Hardware, firmware and software help

hace 7 years
I also got my printer preassembled, and was disappointed wit...

En el foro Others (Archive)

hace 7 years
Pre-assembled MK3. I just took a peek and I see the brown du...

En el foro Others (Archive)

hace 7 years
Is the nozzle suppose to touch the bed during Z calibration?...

En el foro Others (Archive)

hace 7 years
Check the height of the z probe. Should only be able to fit ...

En el foro Others (Archive)

hace 7 years
I had the same issue with b150. Turned off crash detection a...

En el foro Others (Archive)

hace 7 years
I just got my assembled printer and it sounds like yours but...

En el foro Others (Archive)

hace 7 years
Ordered an Orange Assembled MK3 on 10/03/17. Got label creat...

En el foro General discussion, announcements and releases

hace 7 years
i guess it musst habe to do with the amount of filament used...

En el foro How do I print this? (Printing help)

hace 7 years
Received my replacement power supply today, but one of the 3...

En el foro Hardware, firmware and software help

hace 7 years
I am communicating with Prusa support again and they referre...

En el foro General discussion, announcements and releases

hace 7 years
A sock would most likely prevent issues like this:

En el foro Others (Archive)

hace 7 years
Compartir: