Notifications
Clear all
Träd-E
Träd-E
Group: Registered
Joined: 2025/11/24
Eminent Member
2
What's the difference on normal vs blend anyway? is it just ...

In forum How do I print this? (Printing help)

1 week ago
I forgot to mention another trick that I use in this model. ...

In forum PrusaSlicer

3 weeks ago
Here's the shenanigans I've been up to with this/p> I've mos...

In forum PrusaSlicer

3 weeks ago
😘

In forum PrusaSlicer

1 month ago
I'm finding more inconsistent behavior concerning this. Sett...

In forum PrusaSlicer

1 month ago
The solution is here/p> Easy to place, no need for ultra pre...

In forum PrusaSlicer

1 month ago
There should be more time to edit posts on this forum.... Wr...

In forum PrusaSlicer

2 months ago
"single perimeter on top surface" also seems to suffer from ...

In forum PrusaSlicer

2 months ago
The whole reason why I'd like this to work is because using ...

In forum PrusaSlicer

2 months ago
I just now realized the file didn't attach, didn't zip it I ...

In forum PrusaSlicer

2 months ago
I found it! You can infact set the elephants foot compensati...

In forum PrusaSlicer

2 months ago
Thanks for the tip, I'll try that too. I found that increasi...

In forum PrusaSlicer

2 months ago
To clarify further, I need to disable it on the tabs otherwi...

In forum PrusaSlicer

2 months ago
aah, yes, that would be elephants foot compensation which i'...

In forum PrusaSlicer

2 months ago
You could probably inject some custom G-code for the lift bu...

In forum PrusaSlicer

2 months ago
Custom brim/tabs elephant's foot compensation...

In forum PrusaSlicer

2 months ago
scarfjoint enforcer modifier

In forum PrusaSlicer

2 months ago
Hmmm, it just occurred to me that this might be solvable sim...

In forum General discussion, announcements and releases

2 months ago
Probably it's fine, the copper is slightly visible on my too...

In forum Assembly and first prints troubleshooting

2 months ago
Did you figure it out?

In forum Assembly and first prints troubleshooting

2 months ago
Page 1 / 2
Share: