|
Anti-Warping slicing strategy (from Welding) Nel forum PrusaSlicer |
7 months fa |
|
Problem with binder clips is they would interfere with the l... Nel forum Others (Archive) |
5 years fa |
|
Old thread, but I experience the same problem printing large... Nel forum Others (Archive) |
5 years fa |
|
Yes, the latest firmware handles the situation where filamen... Nel forum General discussion, announcements and releases |
6 years fa |
|
Sure enough, first thing I should have done is upgrade the p... Nel forum General discussion, announcements and releases |
6 years fa |
|
Yes the MMU2 starts, moves left and right. I also did the le... Nel forum General discussion, announcements and releases |
6 years fa |
|
Without any changes to my existing GCODE, I manually pushed... Nel forum General discussion, announcements and releases |
6 years fa |
|
Hmmm....so I have to manually edit my existing GCODE and add... Nel forum General discussion, announcements and releases |
6 years fa |
|
ok thanks, but it's not obvious to me how I load the hot end... Nel forum General discussion, announcements and releases |
6 years fa |
|
MMU, Single Mode, Auto-Deplete feature with CURA GCODE? Nel forum General discussion, announcements and releases |
6 years fa |
|
I'll add my vote for a Prusa i3 MK3 XL. I would buy one if i... Nel forum Improvements (Archive) |
6 years fa |
|
bump Nel forum Others (Archive) |
6 years fa |
|
I created an account to also say thanks.
I used this metho... Nel forum Print tips (Archive) |
6 years fa |
