Prusa3D Forum

Notifications

Clear all

Tonias

Groupe: Enregistré

A(ont) rejoint: 2015/11/05

Active Member

	yup, they are. Dans le forum Software (Archive)	il y a 8 years
	I am really interested in this, too. How high is the resista... Dans le forum Print tips (Archive)	il y a 8 years
	Have you seen the guide about replacing the PEI-sheet? On ... Dans le forum Hardware, firmware and software help	il y a 8 years
	My connectors are polarised, so it would require quite a bit... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Ah I see 🙂 Well, since the Titan is marketed as an upgrade... Dans le forum Improvements (Archive)	il y a 8 years
	I agree. This is my method of choice now for ABS and PLA. I... Dans le forum Print tips (Archive)	il y a 8 years
	Any reason not to just plug in the x-carriage motor connecto... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	The E3D Titan extruder is only for clone users, and not for ... Dans le forum Improvements (Archive)	il y a 8 years
	I got the Titan, will assemble everything this week and shar... Dans le forum Improvements (Archive)	il y a 8 years
	E3D Titan extruder upgrade kit from e3donline.com Dans le forum Improvements (Archive)	il y a 8 years
	Hi Just noticed that in version 2.2.2 the DISABLE_Z is alre... Dans le forum Improvements (Archive)	il y a 9 years
	Your results look great, Jack! Thanks so much for sharing th... Dans le forum Improvements (Archive)	il y a 9 years
	I played around with the printer a little more tonight and t... Dans le forum Software (Archive)	il y a 9 years
	This is really great - thank you Nathan for all your work! ... Dans le forum Software (Archive)	il y a 9 years
	Thank you for this! Will try out those settings today. I've ... Dans le forum Print tips (Archive)	il y a 9 years
	I have the same problem. And Prusa hasn't answered my contac... Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Statistiques du forum

559 Forums

62.3 K Sujets

439.9 K Messages

22 En-ligne

67.7 K Membres

Le dernier des messages: "Kollision erkannt" , jeder Start = Kalibrierung und bei Z Test Kollision Notre nouveau membre: sonic bionic Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé