Notifications
Clear all
Tomáš Ptáčník
Skupina: Registrovaný
Přidal se: 2024/01/04
Active Member
1
|
I did that. Thank you. It seemed to have helped, I had about... In forum Hardware, firmware and software help |
před 10 months | |
|
Ongoing under-extrusion after troubleshooting In forum Hardware, firmware and software help |
před 10 months | |
| Same 3mf, same filament - broken print | před 11 months | |
|
Thank you! Such a banal thing, but your post saved me a lot ... In forum Hardware, firmware and software help |
před 1 year | |
| I had done is using a credit card. The -2.0 height is alread... | před 2 years | |
| Thank you! I adjusted the nozzle even lower, it rests at 2.0... | před 2 years | |
| Bottom layers at edges are messed up | před 2 years |