Avisos
Vaciar todo
Tom Mullebrouck
Tom Mullebrouck
Grupo: Registrado
Registrado: 2017/10/15
Active Member
1
I hope in the next release 3.13.1 :/p>

En el foro Hardware, firmware and software help

hace 1 year
Same here too, no idea why, all sensors work correctly. Star...

En el foro Hardware, firmware and software help

hace 1 year
I have the same problem. My problem with the idler has...

En el foro Hardware, firmware and software help

hace 1 year
Same problem here, if I lose the screws, homing is ok. But i...

En el foro Hardware, firmware and software help

hace 1 year
Raspberry PI with Prusa Link Dashboard on local TFT screen (...

En el foro Introduction & Instructions

hace 1 year
I replaced the hotend with a revo micro and the problems wer...

En el foro Hardware, firmware and software help

hace 2 years
Temperature drops from +20°C in less than a second

En el foro Hardware, firmware and software help

hace 2 years
I replaced the MMU2 motherboard but the problem remained the...

En el foro Hardware, firmware and software help

hace 4 years
Firmware 3.9.0 problem manual extrude

En el foro Hardware, firmware and software help

hace 5 years
Hello, Thx for the tip @geoper2. I loose the screws and rec...

En el foro Assembly and first prints troubleshooting

hace 5 years
MMU2(S) control board freeze

En el foro Hardware, firmware and software help

hace 5 years
Strange noise on z axis (always same place)

En el foro Assembly and first prints troubleshooting

hace 5 years
I have the same problem. In the morning, the probe is good w...

En el foro Assembly and first prints troubleshooting

hace 5 years
I have a problem with the custom G-code. If I changed the cu...

En el foro General discussion, announcements and releases

hace 6 years
I have the new one, but not used yet.

En el foro User mods - OctoPrint, enclosures, nozzles, ...

hace 7 years
Compartir: