todd.m2 – Aktywność – Prusa3D Forum

Notifications

Clear all

todd.m2

Grupa: Zarejestrowany

Dołączył: 2016/05/16

Eminent Member

	That is Awesome!! Thanks for the help. Anyone know what Oran... In forum Others (Archive)	10 years temu
	about 1mm worked for me!! Finally printing. Thanks for the i... In forum Others (Archive)	10 years temu
	Thanks, did not know if the spool was smooth enough for the ... In forum Others (Archive)	10 years temu
	Sure! It printed very well but one issue is one of the front... In forum Others (Archive)	10 years temu
	Finally printing.... The new firmware and seeing the info t... In forum Others (Archive)	10 years temu
	Spool Adapters for 1.75 PLA Spool included in kit In forum Others (Archive)	10 years temu
	I am having the same issue and not getting any help. I email... In forum Others (Archive)	10 years temu
	Thanks! That might help my issue as well. In forum Others (Archive)	10 years temu
	Still having issue getting things calibrated to print. See... In forum Others (Archive)	10 years temu
	Thanks for your reply. Yes, I am sure that the end stop wa... In forum Others (Archive)	10 years temu
	Is your Z axis level todd? Yes, Z axis is level. I also doub... In forum Others (Archive)	10 years temu
	Can you point me to instruction for updating the firmware an... In forum Others (Archive)	10 years temu
	I am having the same issues only my left side is higher then... In forum Others (Archive)	10 years temu
	Thanks for your reply. Yes, I am sure that the end stop wa... In forum Others (Archive)	10 years temu
	Drilled the holes in the end point switch larger for greater... In forum Others (Archive)	10 years temu
	OK, Adjusted PINDA probe a bit lower than suggested in the m... In forum Others (Archive)	10 years temu
	OK, the fun continues. My printer will not pass the Self Che... In forum Others (Archive)	10 years temu
	I found the nut, it was inside the hole where it belongs but... In forum Others (Archive)	10 years temu
	My Extruder housing cracked in the same spot, pretty sure I ... In forum Others (Archive)	10 years temu
	I had the same issues Had to use a knife blade to open up th... In forum Prusa i3 kit (Archive)	10 years temu

Strona 2 / 3 Wstecz Następny

Statystyki Forum

595 Fora

69.9 K Tematy

489.7 K Posty

14 Online

80.7 K Członkowie

Ostatni Post: MMU3 Filament loading / print starting Najnowszy użytkownik:: Laurent Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte