todd.m2 – Activité – Prusa3D Forum

Notifications

Clear all

todd.m2

Groupe: Enregistré

A(ont) rejoint: 2016/05/16

Eminent Member

	That is Awesome!! Thanks for the help. Anyone know what Oran... Dans le forum Others (Archive)	il y a 8 years
	about 1mm worked for me!! Finally printing. Thanks for the i... Dans le forum Others (Archive)	il y a 8 years
	Thanks, did not know if the spool was smooth enough for the ... Dans le forum Others (Archive)	il y a 8 years
	Sure! It printed very well but one issue is one of the front... Dans le forum Others (Archive)	il y a 8 years
	Finally printing.... The new firmware and seeing the info t... Dans le forum Others (Archive)	il y a 8 years
	Spool Adapters for 1.75 PLA Spool included in kit Dans le forum Others (Archive)	il y a 8 years
	I am having the same issue and not getting any help. I email... Dans le forum Others (Archive)	il y a 8 years
	Thanks! That might help my issue as well. Dans le forum Others (Archive)	il y a 8 years
	Still having issue getting things calibrated to print. See... Dans le forum Others (Archive)	il y a 8 years
	Thanks for your reply. Yes, I am sure that the end stop wa... Dans le forum Others (Archive)	il y a 8 years
	Is your Z axis level todd? Yes, Z axis is level. I also doub... Dans le forum Others (Archive)	il y a 8 years
	Can you point me to instruction for updating the firmware an... Dans le forum Others (Archive)	il y a 8 years
	I am having the same issues only my left side is higher then... Dans le forum Others (Archive)	il y a 8 years
	Thanks for your reply. Yes, I am sure that the end stop wa... Dans le forum Others (Archive)	il y a 8 years
	Drilled the holes in the end point switch larger for greater... Dans le forum Others (Archive)	il y a 8 years
	OK, Adjusted PINDA probe a bit lower than suggested in the m... Dans le forum Others (Archive)	il y a 8 years
	OK, the fun continues. My printer will not pass the Self Che... Dans le forum Others (Archive)	il y a 8 years
	I found the nut, it was inside the hole where it belongs but... Dans le forum Others (Archive)	il y a 8 years
	My Extruder housing cracked in the same spot, pretty sure I ... Dans le forum Others (Archive)	il y a 8 years
	I had the same issues Had to use a knife blade to open up th... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Page 2 / 3 Précédent Suivant

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

19 En-ligne

68 K Membres

Le dernier des messages: Too much part cooling after upgrade from mk4 to mk4s? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé