todd.m2 – Activity – Prusa3D Forum

Notifications

Clear all

todd.m2

Group: Registered

Joined: 2016/05/16

Eminent Member

	That is Awesome!! Thanks for the help. Anyone know what Oran... In forum Others (Archive)	8 years ago
	about 1mm worked for me!! Finally printing. Thanks for the i... In forum Others (Archive)	8 years ago
	Thanks, did not know if the spool was smooth enough for the ... In forum Others (Archive)	8 years ago
	Sure! It printed very well but one issue is one of the front... In forum Others (Archive)	8 years ago
	Finally printing.... The new firmware and seeing the info t... In forum Others (Archive)	8 years ago
	Spool Adapters for 1.75 PLA Spool included in kit In forum Others (Archive)	8 years ago
	I am having the same issue and not getting any help. I email... In forum Others (Archive)	8 years ago
	Thanks! That might help my issue as well. In forum Others (Archive)	8 years ago
	Still having issue getting things calibrated to print. See... In forum Others (Archive)	8 years ago
	Thanks for your reply. Yes, I am sure that the end stop wa... In forum Others (Archive)	8 years ago
	Is your Z axis level todd? Yes, Z axis is level. I also doub... In forum Others (Archive)	8 years ago
	Can you point me to instruction for updating the firmware an... In forum Others (Archive)	8 years ago
	I am having the same issues only my left side is higher then... In forum Others (Archive)	8 years ago
	Thanks for your reply. Yes, I am sure that the end stop wa... In forum Others (Archive)	8 years ago
	Drilled the holes in the end point switch larger for greater... In forum Others (Archive)	8 years ago
	OK, Adjusted PINDA probe a bit lower than suggested in the m... In forum Others (Archive)	8 years ago
	OK, the fun continues. My printer will not pass the Self Che... In forum Others (Archive)	8 years ago
	I found the nut, it was inside the hole where it belongs but... In forum Others (Archive)	8 years ago
	My Extruder housing cracked in the same spot, pretty sure I ... In forum Others (Archive)	8 years ago
	I had the same issues Had to use a knife blade to open up th... In forum Prusa i3 kit (Archive)	8 years ago

Page 2 / 3 Prev Next

Forum Statistics

559 Forums

63.1 K Topics

444 K Posts

19 Online

68 K Members

Latest Post: Too much part cooling after upgrade from mk4 to mk4s? Our newest member: etiennep Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed