todd.m2 – Aktivität – Prusa3D Forum

Benachrichtigungen

Alles löschen

todd.m2

Gruppe: Registriert

Beigetreten: 2016/05/16

Eminent Member

	That is Awesome!! Thanks for the help. Anyone know what Oran... Im Forum Others (Archive)	Vor 10 years
	about 1mm worked for me!! Finally printing. Thanks for the i... Im Forum Others (Archive)	Vor 10 years
	Thanks, did not know if the spool was smooth enough for the ... Im Forum Others (Archive)	Vor 10 years
	Sure! It printed very well but one issue is one of the front... Im Forum Others (Archive)	Vor 10 years
	Finally printing.... The new firmware and seeing the info t... Im Forum Others (Archive)	Vor 10 years
	Spool Adapters for 1.75 PLA Spool included in kit Im Forum Others (Archive)	Vor 10 years
	I am having the same issue and not getting any help. I email... Im Forum Others (Archive)	Vor 10 years
	Thanks! That might help my issue as well. Im Forum Others (Archive)	Vor 10 years
	Still having issue getting things calibrated to print. See... Im Forum Others (Archive)	Vor 10 years
	Thanks for your reply. Yes, I am sure that the end stop wa... Im Forum Others (Archive)	Vor 10 years
	Is your Z axis level todd? Yes, Z axis is level. I also doub... Im Forum Others (Archive)	Vor 10 years
	Can you point me to instruction for updating the firmware an... Im Forum Others (Archive)	Vor 10 years
	I am having the same issues only my left side is higher then... Im Forum Others (Archive)	Vor 10 years
	Thanks for your reply. Yes, I am sure that the end stop wa... Im Forum Others (Archive)	Vor 10 years
	Drilled the holes in the end point switch larger for greater... Im Forum Others (Archive)	Vor 10 years
	OK, Adjusted PINDA probe a bit lower than suggested in the m... Im Forum Others (Archive)	Vor 10 years
	OK, the fun continues. My printer will not pass the Self Che... Im Forum Others (Archive)	Vor 10 years
	I found the nut, it was inside the hole where it belongs but... Im Forum Others (Archive)	Vor 10 years
	My Extruder housing cracked in the same spot, pretty sure I ... Im Forum Others (Archive)	Vor 10 years
	I had the same issues Had to use a knife blade to open up th... Im Forum Prusa i3 kit (Archive)	Vor 10 years

Seite 2 / 3 Vorherige Nächstes

Forums-Statistiken

595 Foren

69.9 K Themen

489.6 K Beiträge

13 Online

80.7 K Mitglieder

Letzter Beitrag: As of 6.4.0, the XL still crashes toolheads into one another. It is inexcusable. Unser neuestes Mitglied: Laurent Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen