todd.m2 – Aktivita – Prusa3D Forum

Notifications

Clear all

todd.m2

Skupina: Registrovaný

Přidal se: 2016/05/16

Eminent Member

	That is Awesome!! Thanks for the help. Anyone know what Oran... In forum Others (Archive)	před 10 years
	about 1mm worked for me!! Finally printing. Thanks for the i... In forum Others (Archive)	před 10 years
	Thanks, did not know if the spool was smooth enough for the ... In forum Others (Archive)	před 10 years
	Sure! It printed very well but one issue is one of the front... In forum Others (Archive)	před 10 years
	Finally printing.... The new firmware and seeing the info t... In forum Others (Archive)	před 10 years
	Spool Adapters for 1.75 PLA Spool included in kit In forum Others (Archive)	před 10 years
	I am having the same issue and not getting any help. I email... In forum Others (Archive)	před 10 years
	Thanks! That might help my issue as well. In forum Others (Archive)	před 10 years
	Still having issue getting things calibrated to print. See... In forum Others (Archive)	před 10 years
	Thanks for your reply. Yes, I am sure that the end stop wa... In forum Others (Archive)	před 10 years
	Is your Z axis level todd? Yes, Z axis is level. I also doub... In forum Others (Archive)	před 10 years
	Can you point me to instruction for updating the firmware an... In forum Others (Archive)	před 10 years
	I am having the same issues only my left side is higher then... In forum Others (Archive)	před 10 years
	Thanks for your reply. Yes, I am sure that the end stop wa... In forum Others (Archive)	před 10 years
	Drilled the holes in the end point switch larger for greater... In forum Others (Archive)	před 10 years
	OK, Adjusted PINDA probe a bit lower than suggested in the m... In forum Others (Archive)	před 10 years
	OK, the fun continues. My printer will not pass the Self Che... In forum Others (Archive)	před 10 years
	I found the nut, it was inside the hole where it belongs but... In forum Others (Archive)	před 10 years
	My Extruder housing cracked in the same spot, pretty sure I ... In forum Others (Archive)	před 10 years
	I had the same issues Had to use a knife blade to open up th... In forum Prusa i3 kit (Archive)	před 10 years

Stránka 2 / 3 Předchozí Další

Fórum Statistiky

595 Fóra

69.9 K Témata

489.7 K Příspěvky

14 Online

80.7 K Uživatelé

Poslední Příspěvek: Networking issue with Core One+ Nový Uživatel: Laurent Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed