Notifications
Clear all
TK_bit_twiddler
Groupe: Enregistré
A(ont) rejoint: 2018/06/07
Active Member
1
|
Per my statement about not being savvy at Unix, I'm going to... Dans le forum PrusaSlicer |
il y a 5 months | |
|
Installing PrusaSlicer on Chromebook running Debian 12 (book... Dans le forum PrusaSlicer |
il y a 5 months | |
|
Thanks gaston.d3 and Frio for your insights. I'm not planni... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Which linux variants does Slic3r PE run on? Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Recommended RPi slicer setup for newby Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Good news here. The eSun PETG glossy black works much bette... Dans le forum Others (Archive) |
il y a 6 years | |
|
I was able to print a small object (5 minute print) last nig... Dans le forum Others (Archive) |
il y a 6 years | |
|
I have the same problem with eSun PETG black. Sounds like I... Dans le forum Others (Archive) |
il y a 6 years |