Notifications
Clear all
TK_bit_twiddler
Group: Registered
Joined: 2018/06/07
Active Member
1
|
Per my statement about not being savvy at Unix, I'm going to... In forum PrusaSlicer |
5 months ago | |
|
Installing PrusaSlicer on Chromebook running Debian 12 (book... In forum PrusaSlicer |
5 months ago | |
|
Thanks gaston.d3 and Frio for your insights. I'm not planni... In forum Hardware, firmware and software help |
6 years ago | |
|
Which linux variants does Slic3r PE run on? In forum Hardware, firmware and software help |
6 years ago | |
|
Recommended RPi slicer setup for newby In forum Hardware, firmware and software help |
6 years ago | |
|
Good news here. The eSun PETG glossy black works much bette... In forum Others (Archive) |
6 years ago | |
|
I was able to print a small object (5 minute print) last nig... In forum Others (Archive) |
6 years ago | |
|
I have the same problem with eSun PETG black. Sounds like I... In forum Others (Archive) |
6 years ago |