Prusa3D Forum

Notifications

Clear all

Timo

Skupina: PrusaLink-beta

Přidal se: 2018/07/25

Název: Member

	Yes, Prusalink source code is available on the Prusa Github.... In forum General discussion & User Experience & Ideas	před 2 years
	Yes, using USB. It's fine because I have it connected to my ... In forum General discussion & User Experience & Ideas	před 2 years
	I agree that it is SUPER annoying. But I tbh do not use th... In forum General discussion & User Experience & Ideas	před 2 years
	@stefan-11 are you talking about Prusalink on the Mini? In forum General discussion & User Experience & Ideas	před 2 years
	Over the last few weeks, there are lots of merges and pull r... In forum Introduction & Instructions	před 2 years
	No worries.I ran pip3 install -U in both directories instead... In forum General discussion & User Experience & Ideas	před 3 years
	Seems like Banana Pi is also supported on/p> In forum General discussion & User Experience & Ideas	před 3 years
	@Tojik You are an absolute legend! This screenshot is f... In forum General discussion & User Experience & Ideas	před 3 years
	I would try to connect to it using Pronterface (any serial t... In forum General discussion, announcements and releases	před 3 years
	Do you swap the flexplate for a new one? Because most would ... In forum General discussion & User Experience & Ideas	před 3 years
	I have mine connected using the pin headers but had issues b... In forum Introduction & Instructions	před 3 years
	That is not how it works. You will have to 'SET_PRINTER_PREP... In forum General discussion & User Experience & Ideas	před 3 years
	Looked up the topic for you -> Using USB Using USB and an... In forum Introduction & Instructions	před 3 years
	Can you elaborate on 'the same time'? Same percentage on... In forum Introduction & Instructions	před 3 years
	For me, 0.6.0 is rock solid. I have had no real issues with ... In forum Introduction & Instructions	před 3 years
	This question is a duplicate and was answered in this topic In forum General discussion & User Experience & Ideas	před 3 years
	Yes I have. I have tried to connect my MK2.5S using USB usin... In forum Introduction & Instructions	před 3 years
	The only real reasons that I can think of to not include the... In forum Introduction & Instructions	před 3 years
	Mini would be nice but it's a different beast from the MK3 a... In forum Introduction & Instructions	před 3 years
	I wouldn't mind just having an option to just mount an smb s... In forum General discussion & User Experience & Ideas	před 3 years

Stránka 1 / 2 Další

Fórum Statistiky

565 Fóra

63.9 K Témata

447.7 K Příspěvky

18 Online

69.6 K Uživatelé

Poslední Příspěvek: How do I set the GCODE macros to not raise the printhead so much? Nový Uživatel: Mechman0124 Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed