Prusa3D Forum

Notifications

Clear all

Timo

Groupe: PrusaLink-beta

A(ont) rejoint: 2018/07/25

Titre: Membre

	Yes, Prusalink source code is available on the Prusa Github.... Dans le forum General discussion & User Experience & Ideas	il y a 2 years
	Yes, using USB. It's fine because I have it connected to my ... Dans le forum General discussion & User Experience & Ideas	il y a 2 years
	I agree that it is SUPER annoying. But I tbh do not use th... Dans le forum General discussion & User Experience & Ideas	il y a 2 years
	@stefan-11 are you talking about Prusalink on the Mini? Dans le forum General discussion & User Experience & Ideas	il y a 2 years
	Over the last few weeks, there are lots of merges and pull r... Dans le forum Introduction & Instructions	il y a 2 years
	No worries.I ran pip3 install -U in both directories instead... Dans le forum General discussion & User Experience & Ideas	il y a 3 years
	Seems like Banana Pi is also supported on/p> Dans le forum General discussion & User Experience & Ideas	il y a 3 years
	@Tojik You are an absolute legend! This screenshot is f... Dans le forum General discussion & User Experience & Ideas	il y a 3 years
	I would try to connect to it using Pronterface (any serial t... Dans le forum General discussion, announcements and releases	il y a 3 years
	Do you swap the flexplate for a new one? Because most would ... Dans le forum General discussion & User Experience & Ideas	il y a 3 years
	I have mine connected using the pin headers but had issues b... Dans le forum Introduction & Instructions	il y a 3 years
	That is not how it works. You will have to 'SET_PRINTER_PREP... Dans le forum General discussion & User Experience & Ideas	il y a 3 years
	Looked up the topic for you -> Using USB Using USB and an... Dans le forum Introduction & Instructions	il y a 3 years
	Can you elaborate on 'the same time'? Same percentage on... Dans le forum Introduction & Instructions	il y a 3 years
	For me, 0.6.0 is rock solid. I have had no real issues with ... Dans le forum Introduction & Instructions	il y a 3 years
	This question is a duplicate and was answered in this topic Dans le forum General discussion & User Experience & Ideas	il y a 3 years
	Yes I have. I have tried to connect my MK2.5S using USB usin... Dans le forum Introduction & Instructions	il y a 3 years
	The only real reasons that I can think of to not include the... Dans le forum Introduction & Instructions	il y a 3 years
	Mini would be nice but it's a different beast from the MK3 a... Dans le forum Introduction & Instructions	il y a 3 years
	I wouldn't mind just having an option to just mount an smb s... Dans le forum General discussion & User Experience & Ideas	il y a 3 years

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

64.1 K Sujets

449.1 K Messages

22 En-ligne

70.2 K Membres

Le dernier des messages: MK4S TPU auf glatter Druckplatte Notre nouveau membre: shugobha Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé