Prusa3D Forum

Notifications

Clear all

TheSlowPrinter

Groupe: Enregistré

A(ont) rejoint: 2023/02/21

Active Member

	Have now printed a part, a bit higher than where the crashes... Dans le forum General discussion, announcements and releases	il y a 1 year
	Additional to my original Prusa MK3s, I also have a AliExpre... Dans le forum General discussion, announcements and releases	il y a 1 year
	Thanks Diem, sounds too obvious to have thought about myself... Dans le forum General discussion, announcements and releases	il y a 1 year
	Crash on Y axis detected - no reason to see why Dans le forum General discussion, announcements and releases	il y a 1 year
	Oh I love it, when I have a problem with it's solution docum... Dans le forum Hardware, firmware and software help	il y a 2 years
	After some days of successful prints, the error returned aga... Dans le forum Hardware, firmware and software help	il y a 3 years
	some problem encountered z leveling enforced error is back. ... Dans le forum Hardware, firmware and software help	il y a 3 years
	Change orientation / direction of support? Dans le forum PrusaSlicer	il y a 3 years

Statistiques du forum

595 Forums

68.9 K Sujets

481.8 K Messages

18 En-ligne

77.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé