Notifications
Clear all

TheSlowPrinter
Group: Registered
Joined: 2023/02/21
Active Member
1
Have now printed a part, a bit higher than where the crashes... | 11 months ago | |
Additional to my original Prusa MK3s, I also have a AliExpre... | 12 months ago | |
Thanks Diem, sounds too obvious to have thought about myself... | 12 months ago | |
Crash on Y axis detected - no reason to see why | 12 months ago | |
Oh I love it, when I have a problem with it's solution docum... In forum Hardware, firmware and software help |
2 years ago | |
After some days of successful prints, the error returned aga... In forum Hardware, firmware and software help |
2 years ago | |
some problem encountered z leveling enforced error is back. ... In forum Hardware, firmware and software help |
3 years ago | |
Change orientation / direction of support? In forum PrusaSlicer |
3 years ago |