Prusa3D Forum

Notifications

Clear all

thebrucecrowder

Grupa: Zarejestrowany

Dołączył: 2020/05/04

Active Member

	M112 code and funky print In forum Hardware, firmware and software help	3 years temu
	After upgrade, Mk2 nozzle heater can't keep up with Mk2.5S f... In forum Hardware, firmware and software help	4 years temu
	@joantabb Thanks so much for the input. I did check the inpu... In forum Hardware, firmware and software help	4 years temu
	@karl-herbert I had this same issue. I checked my heater res... In forum Hardware, firmware and software help	4 years temu
	I believe I found my issue. Hotend heater resistance is 5.7 ... In forum Hardware, firmware and software help	4 years temu
	Did you ever find a solution to this? I am having similar is... In forum Hardware, firmware and software help	4 years temu
	Hi there. I'm wrestling with similar issues and I'm just won... In forum Hardware, firmware and software help	4 years temu
	IR sensor does not fit in MK2.5s upgrade - I think I printed... In forum Assembly and first prints troubleshooting	5 years temu

Statystyki Forum

559 Fora

63.1 K Tematy

444 K Posty

23 Online

68 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte