Avisos
Vaciar todo
thebrucecrowder
Grupo: Registrado
Registrado: 2020/05/04
Active Member
1
|
M112 code and funky print En el foro Hardware, firmware and software help |
hace 3 years | |
|
After upgrade, Mk2 nozzle heater can't keep up with Mk2.5S f... En el foro Hardware, firmware and software help |
hace 4 years | |
|
@joantabb Thanks so much for the input. I did check the inpu... En el foro Hardware, firmware and software help |
hace 4 years | |
|
@karl-herbert I had this same issue. I checked my heater res... En el foro Hardware, firmware and software help |
hace 4 years | |
|
I believe I found my issue. Hotend heater resistance is 5.7 ... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Did you ever find a solution to this? I am having similar is... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Hi there. I'm wrestling with similar issues and I'm just won... En el foro Hardware, firmware and software help |
hace 4 years | |
|
IR sensor does not fit in MK2.5s upgrade - I think I printed... En el foro Assembly and first prints troubleshooting |
hace 5 years |