|
There seem to be parts, but which would I need and how do I ... In forum Hardware, firmware and software help |
3 months ago |
|
Oh no! Pinda broke off In forum Hardware, firmware and software help |
3 months ago |
|
Hi, Thanks Neophyl. In trying to post what you suggest, I s... In forum Hardware, firmware and software help |
4 months ago |
|
I cannot see the attachments, so trying again. In forum Hardware, firmware and software help |
4 months ago |
|
Here are the 230 and 280 gcode files in case they are at fau... In forum Hardware, firmware and software help |
4 months ago |
|
Printer ignores gcode temperatures In forum Hardware, firmware and software help |
4 months ago |
|
Oh, you star! I was adjusting in the 0.1 to 0.2 mm range and... In forum Hardware, firmware and software help |
4 years ago |
|
Thanks fuchsr. Apart from my reservations about this, how a... In forum Hardware, firmware and software help |
4 years ago |
|
Oh, I do not want to mess with the PINDA sensor. It was set... In forum Hardware, firmware and software help |
4 years ago |
|
Z no longer goes low enough In forum Hardware, firmware and software help |
4 years ago |
|
I found it was caused by a fragment of PLA trapped under the... In forum Hardware, firmware and software help |
4 years ago |
