Notifications
Clear all
The Grue
The Grue
Groupe: Enregistré
A(ont) rejoint: 2020/09/19
Eminent Member
2
Hello, In the last months I printed several pieces of jewell...

Dans le forum Hardware, firmware and software help

il y a 3 years
Thanks, I used 0.2mm QUALITY and it prints perfectly 🙂

Dans le forum Hardware, firmware and software help

il y a 3 years
Thanks, I'll try that tomorrow.

Dans le forum Hardware, firmware and software help

il y a 3 years
Missing image (hopefully)

Dans le forum Hardware, firmware and software help

il y a 3 years
Nozzle clogs most of the time

Dans le forum Hardware, firmware and software help

il y a 3 years
@cwbullet That's a bit complicated for the X axis... I'll di...

Dans le forum General discussion, announcements and releases

il y a 4 years
I was wrong, the extruder moves on the X axis by gravity. ...

Dans le forum General discussion, announcements and releases

il y a 4 years
How can I influence this if it is not belt tension related? ...

Dans le forum General discussion, announcements and releases

il y a 4 years
Thanks for all your ideas! I'll check everything and cross m...

Dans le forum General discussion, announcements and releases

il y a 4 years
Print partly "shifted" to the right - Collision?

Dans le forum General discussion, announcements and releases

il y a 4 years
Ah, I see. I misunderstood that. I thought that article is o...

Dans le forum General discussion, announcements and releases

il y a 4 years
That explains it quite well 🙂 Thanks, nice that the solitio...

Dans le forum General discussion, announcements and releases

il y a 4 years
Self printed fan shroud wrapped after a few prints

Dans le forum General discussion, announcements and releases

il y a 4 years
Best practice to share setup for filament?

Dans le forum General discussion, announcements and releases

il y a 4 years
Can you recommend a source for silicone socks?

Dans le forum General discussion, announcements and releases

il y a 4 years
Wow, so many answers from Illustrious, Famed and Noble membe...

Dans le forum General discussion, announcements and releases

il y a 4 years
I tried to print again, several times, and it's not possible...

Dans le forum General discussion, announcements and releases

il y a 4 years
Printer stops extruding - NOT CLOGGED!

Dans le forum General discussion, announcements and releases

il y a 4 years
Failing supports with PRUSAMENT Vanilla White

Dans le forum General discussion, announcements and releases

il y a 4 years
@peter-c20 Yes, my filament came with a bag of silica. I hop...

Dans le forum General discussion, announcements and releases

il y a 4 years
Page 1 / 2
Partager :