Notifications
Clear all
The Grue
The Grue
Skupina: Registrovaný
Přidal se: 2020/09/19
Eminent Member
2
Hello, In the last months I printed several pieces of jewell...

In forum Hardware, firmware and software help

před 3 years
Thanks, I used 0.2mm QUALITY and it prints perfectly 🙂

In forum Hardware, firmware and software help

před 3 years
Thanks, I'll try that tomorrow.

In forum Hardware, firmware and software help

před 3 years
Missing image (hopefully)

In forum Hardware, firmware and software help

před 3 years
Nozzle clogs most of the time

In forum Hardware, firmware and software help

před 3 years
@cwbullet That's a bit complicated for the X axis... I'll di...

In forum General discussion, announcements and releases

před 4 years
I was wrong, the extruder moves on the X axis by gravity. ...

In forum General discussion, announcements and releases

před 4 years
How can I influence this if it is not belt tension related? ...

In forum General discussion, announcements and releases

před 4 years
Thanks for all your ideas! I'll check everything and cross m...

In forum General discussion, announcements and releases

před 4 years
Print partly "shifted" to the right - Collision?

In forum General discussion, announcements and releases

před 4 years
Ah, I see. I misunderstood that. I thought that article is o...

In forum General discussion, announcements and releases

před 4 years
That explains it quite well 🙂 Thanks, nice that the solitio...

In forum General discussion, announcements and releases

před 4 years
Self printed fan shroud wrapped after a few prints

In forum General discussion, announcements and releases

před 4 years
Best practice to share setup for filament?

In forum General discussion, announcements and releases

před 4 years
Can you recommend a source for silicone socks?

In forum General discussion, announcements and releases

před 4 years
Wow, so many answers from Illustrious, Famed and Noble membe...

In forum General discussion, announcements and releases

před 4 years
I tried to print again, several times, and it's not possible...

In forum General discussion, announcements and releases

před 4 years
Printer stops extruding - NOT CLOGGED!

In forum General discussion, announcements and releases

před 4 years
Failing supports with PRUSAMENT Vanilla White

In forum General discussion, announcements and releases

před 4 years
@peter-c20 Yes, my filament came with a bag of silica. I hop...

In forum General discussion, announcements and releases

před 4 years
Stránka 1 / 2
Share: