Avisos
Vaciar todo
TerryPro
Grupo: Registrado
Registrado: 2020/12/25
Active Member
1
I also had the issue this morning, which may have been (like... En el foro Hardware, firmware and software help |
hace 3 years | |
Prusaslicer Default Settings? En el foro PrusaSlicer |
hace 3 years | |
Lynn's and JSW's responses are bang on. Bob's settings work ... En el foro PrusaSlicer |
hace 3 years | |
Up until a week ago, my filament tips were always spot on, w... | hace 3 years | |
I was printing multi-coloured models all the time, with litt... | hace 3 years | |
@outofmuc Any updates? En el foro Assembly and first prints troubleshooting |
hace 4 years | |
@bobstro I'm a newbie who was just as frustrated as others w... En el foro PrusaSlicer |
hace 4 years |