Notifications
Clear all
TerryPro
Group: Registered
Joined: 2020/12/25
Active Member
1
|
I also had the issue this morning, which may have been (like... In forum Hardware, firmware and software help |
3 years ago | |
|
Prusaslicer Default Settings? In forum PrusaSlicer |
3 years ago | |
|
Lynn's and JSW's responses are bang on. Bob's settings work ... In forum PrusaSlicer |
3 years ago | |
| Up until a week ago, my filament tips were always spot on, w... | 3 years ago | |
| I was printing multi-coloured models all the time, with litt... | 3 years ago | |
| @outofmuc Any updates? | 4 years ago | |
|
@bobstro I'm a newbie who was just as frustrated as others w... In forum PrusaSlicer |
4 years ago |