Prusa3D Forum

Notifications

Clear all

Terry

Groupe: Enregistré

A(ont) rejoint: 2021/01/29

Active Member

	Hm, I could swear I posted an update here, with some photos.... Dans le forum How do I print this? (Printing help)	il y a 9 months
	This is actually a great suggestion. I guess I'll try that; ... Dans le forum How do I print this? (Printing help)	il y a 9 months
	Printing a smooth disc does not work vertically Dans le forum How do I print this? (Printing help)	il y a 9 months
	Contests - how to join Dans le forum General discussion, announcements and releases	il y a 10 months
	Brilliant suggestion! I have the same issue as Amir S. and w... Dans le forum General discussion, announcements and releases	il y a 10 months
	I'm trying this approach, as suggested by neophyl. Yes this ... Dans le forum How do I print this? (Printing help)	il y a 1 year
	Thanks, good suggestions. I tried a Dremel but it didn't do ... Dans le forum How do I print this? (Printing help)	il y a 1 year
	How to eliminate artifacts in round holes (without supports) Dans le forum How do I print this? (Printing help)	il y a 1 year
	If you add supports in prusaslicer, it adds a big mass of ma... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Pasting in the app key did the trick; thanks for the tip. No... Dans le forum PrusaSlicer	il y a 4 years
	why did this make spaghetti -- needs supports? Dans le forum How do I print this? (Printing help)	il y a 4 years
	Well I installed OctoPrint on my Mac, following the directio... Dans le forum PrusaSlicer	il y a 4 years
	Why is Send G-Code disabled in 2.3.0+ Dans le forum PrusaSlicer	il y a 4 years
	@peter-m-3 I'm a beginner and after cleaning it and using al... Dans le forum How do I print this? (Printing help)	il y a 4 years

Statistiques du forum

559 Forums

62.9 K Sujets

442.9 K Messages

20 En-ligne

67.7 K Membres

Le dernier des messages: Gibt es ein Update von MK3.5 zu Mk4/S Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé