Čeština
Fóra
Uživatelé
Terry
Aktivita
 
Notifications
Clear all
Terry
Terry
Skupina: Registrovaný
Přidal se: 2021/01/29
Active Member
1
Profile Aktivita
Hm, I could swear I posted an update here, with some photos....

In forum How do I print this? (Printing help)

 před 9 months
This is actually a great suggestion. I guess I'll try that; ...

In forum How do I print this? (Printing help)

 před 9 months
Printing a smooth disc does not work vertically

In forum How do I print this? (Printing help)

 před 9 months
Contests - how to join

In forum General discussion, announcements and releases

 před 10 months
Brilliant suggestion! I have the same issue as Amir S. and w...

In forum General discussion, announcements and releases

 před 10 months
I'm trying this approach, as suggested by neophyl. Yes this ...

In forum How do I print this? (Printing help)

 před 1 year
Thanks, good suggestions. I tried a Dremel but it didn't do ...

In forum How do I print this? (Printing help)

 před 1 year
How to eliminate artifacts in round holes (without supports)

In forum How do I print this? (Printing help)

 před 1 year
If you add supports in prusaslicer, it adds a big mass of ma...

In forum How do I print this? (Printing help)

 před 4 years
Pasting in the app key did the trick; thanks for the tip. No...

In forum PrusaSlicer

 před 4 years
why did this make spaghetti -- needs supports?

In forum How do I print this? (Printing help)

 před 4 years
Well I installed OctoPrint on my Mac, following the directio...

In forum PrusaSlicer

 před 4 years
Why is Send G-Code disabled in 2.3.0+

In forum PrusaSlicer

 před 4 years
@peter-m-3 I'm a beginner and after cleaning it and using al...

In forum How do I print this? (Printing help)

 před 4 years
Share: