Tekjunke – Activité – Prusa3D Forum

Notifications

Clear all

Tekjunke

Groupe: Enregistré

A(ont) rejoint: 2021/06/12

Eminent Member

	Yes, I’ve completed multiple factory resets and recalibrated... Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 2 years
	Mini+ upgrade mods are causing lots of frustration Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 2 years
	Is there a picture thread? Dans le forum General discussion, announcements and releases	il y a 2 years
	Thank you, off to pick some up now. It just so happens that ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	I tried a simple first layer calibration on my MK3 with the ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	A followup to this, I ended up tearing the printer all the w... Dans le forum Hardware, firmware and software help	il y a 3 years
	@turro75 That’s exactly what I was looking for. Not sure how... Dans le forum Hardware, firmware and software help	il y a 3 years
	X-axis alignment issue Dans le forum Hardware, firmware and software help	il y a 3 years
	Thanks for all the replies an advice. I think I got to the b... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Here’s another attempt with -1.200 Dans le forum How do I print this? (Printing help)	il y a 3 years
	1.250 looks pretty good and 1.0 barely sticks Dans le forum How do I print this? (Printing help)	il y a 3 years
	-1.500 z axis is certainly too low Dans le forum How do I print this? (Printing help)	il y a 3 years
	Prusament PETG help Dans le forum How do I print this? (Printing help)	il y a 3 years

Page 2 / 2 Précédent

Statistiques du forum

559 Forums

62.8 K Sujets

442.2 K Messages

18 En-ligne

67.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé